Lambretta TV 175 Series 1
-
Tv 175 Series 1
Lambretta TV 175 Series 1.
Technical Specification
| Model | TV 175 Series 1 |
| Amount Produced | 10086 |
| Production Dates | September 1957 – December 1958 |
| Frame Prefix | 175TVS |
| Engine Prefix | 175TV |
| Frame Starting Number | 01001 |
| Engine Starting Number | 01001 |
| Homologation | Unknown |
| Engine | 170cc, two stroke, 60x60mm |
| Power and Rate | 8.6hp at 4600rpm |
| Compression Ratio | 1:7.6 |
| Head and Cylinder | Aluminium and cast iron |
| Engine Cooling | Forced Air |
| Ignition | Filso Magneto |
| Spark Advance | 26' – 28' 32 - 33 mm on the circumference of the magneto. |
| Point Setting | .35-.45 mm |
| Carburetor | dell'orto MB 23 BS5 |
| Choke | 23mm |
| Slide | 70 |
| Needle | E15 |
| Atomiser | 260b |
| Main Jet | 105 |
| Pilot Jet | 45 |
| Starter | 60 |
| Float | 6.5 grams |
| Starter | Pedal |
| Crankcase oil | Agip Energol SAE 30 1000cc |
| Transmission Oil | |
| Oil / Gas Mix | 6% |
| Clutch | Multiple discs in oil bath |
| Gears | 4 speed with hand shifter |
| 1st | |
| 2nd | |
| 3rd | |
| 4th | |
| Primary Transmission | Duplex chain |
| Secondary Transmission | Gear |
| Frame | Steel tubing of strong 1290mm sections |
| Front Suspension | Oscilating conecting rods with hydraulic shocks |
| Rear Suspension | Torsion bar attached to motor with a single shock |
| Wheels | Dismountable wheels |
| Tires | 3.50 x 8 |
| Tire Presure | Front 1.0 ATM, rear 1.50 ATM |
| Brakes | Drum |
| Dry Weight | 120kg |
| Km Per Gallon | 3.2lts per 100km |
| Fuel Capacity | 8.5lt |
| Max Speed | 103kmh |
| Initial Price | 185,000 Italian Lira |
| Electrical System | 6 volt with 6.7 volt battery |
| Sparkplug | Bosch 225 / 240 short thread |
| wheel Base | |
| Maximum Length | |
| Ground Clearance | |
| Maximum Seat Hight | |
| Minimum Turning Radius | |
| Colour | Ivory 8028 |
Copyright © 2018-2025 - All Rights Reserved - British lambretta Archive
Design by John Walklate