Lambretta Li 125 Series 2
Lambretta Li 125 Series 2.
Technical Specification
Model | LI 125 Series 2 |
Amount Produced | 111087 |
Production Dates | October 1959 – November 1961 |
Frame Prefix | 125LI |
Engine Prefix | 125LI |
Frame Starting Number | 703001 and 300001 from June 11961 |
Engine Starting Number | 547748 (varified) |
Homologation | 0902 OM |
Engine | 123cc, two stroke, 52x58mm |
Power and Rate | 5.2hp at 5200rpm |
Compression Ratio | 1:5.2 |
Head and Cylinder | Aluminium and cast iron |
Engine Cooling | Forced Air |
Ignition | Filso,Ducati or Dansi magneto |
Spark Advance | 22' – 24' 32 - 33 mm on the circumference of the magneto. |
Point Setting | .35-.45 mm |
Carburetor | 1960: dell'orto MA 18 BS5 1961: dell'orto MA 18 BS7 |
Choke | 18mm |
Slide | 50 |
Needle | D20 |
Atomiser | 260b |
Main Jet | 92 |
Pilot Jet | 35 |
Starter | 55 |
Float | 6.5 grams |
Starter | Pedal |
Crankcase oil | Agip Energol SAE 90 600cc |
Transmission Oil | |
Oil / Gas Mix | 2% |
Clutch | Multiple discs in oil bath |
Gears | 4 speed with hand shifter |
1st | 1: 5,666 |
2nd | 1: 3,500 |
3rd | 1: 2,437 |
4th | 1: 1,842 – 79,5 kmh |
Primary Transmission | Duplex chain |
Secondary Transmission | |
Frame | Steel tubing of strong 1290mm sections |
Front Suspension | Oscilating conecting rods |
Rear Suspension | Torsion bar attached to motor with a single shock |
Wheels | Dismountable wheels |
Tires | 3.50 x 10 pirelli or ceat |
Tire Presure | Front .9 ATM, rear 1.25 ATM |
Brakes | Drum |
Dry Weight | 104kg |
Km Per Gallon | 2.1lts per 100km |
Fuel Capacity | 8.5lt |
Max Speed | 75-77kmh |
Initial Price | 132,000 Italian Lira |
Electrical System | 6 volt |
Sparkplug | Bosch 225 – 240 long thread |
wheel Base | 1300mm |
Maximum Length | 1830mm |
Ground Clearance | 165mm |
Maximum Seat Hight | |
Minimum Turning Radius | |
Maximum Width | 710mm |
Maximum Hight | 1060mm |
Colour | Dawn Grey 8019 |
Dark Steel Grey 8040 (side panels only) |
Copyright © 2018-2025 - All Rights Reserved - British lambretta Archive
Design by John Walklate