Lambretta Furgone D 125
The Lambretta Furgone D 125.
Technical Specification
Model | Furgone D 125 |
Production Started | January 1954 |
Production Ended | August 1955 |
Frame Prefix | T40 |
Engine Prefix | 125M |
Starting Frame N° | 100001 |
Starting Engine N° | 100001 |
Amount Produced | 8280 |
Engine | 123cc, two stroke, 52x58mm |
Power & Rate | 5.1HP at 5,000RPM |
Compression Ratio | 1:6.3 |
Head & Cylinder | Aluminium & Cast Iron |
Engine Cooling | Forced Air |
Crankcase Oil | Mobil Lube GX 140/250grams |
Starter | Pedal |
Clutch | Multiple discs in oil bath |
Gears | 3 speed hand shifter (teleflex) |
Gear Ratios | 1st 1:23.09 |
2nd 1:11.40 | |
3rd 1:6.06 | |
Ignition | Filso or Marelli |
Spark Advance | 28°-34° Filso. 36.5mm Marelli on the circumfrance of the flywheel |
Point Settings | .40-.50mm |
Sparkplug | Bosch 225, short thread |
Primary | Gear |
Secondary | Shaft and differential |
Transmission Oil | Special Mobil grease 4 |
Carburetor | dell'orto MA18B3 or Zenith 18MTC |
Carburation | MA18B3 Main 70, Pilot 45, valve 75. Or 18MTC. Main 80. |
Fuel Mix | 5.00% |
Fuel Consumption | 1lt per 28-30km |
Fuel Capacity | 7.6lt .6 reserve |
Range | |
Maximum Speed | 53.7km/h |
Brake Type | Front: Mechanically controlled drum |
Rear: Hydraulically controlled drum | |
Tire | 4.00 x 8 |
Tire Pressure | Front: 1.0ATM |
Rear: 2ATM | |
Front | Oscillating connecting rods |
Rear | Rigid cross beam with longitudinal leaf springs |
Dry Weight | 149kg open trunk, 179kg closed compartment |
Longitudinal Dimension | 2,500mm |
Transversal Dimension | 1,300mm |
Vertical Dimension Box | 350mm |
Max Hight | 960mm |
Ground Clearance | 140mm |
Wheel Base | 1,650mm |
Track Width | 1,150mm |
Minimum Turning Radius | 1,700mm |
Load Capacity | 300kg |
System | 6 Volt with 7amp battery |
Frame | Steel tubing with 1,650mm resistence |
Cab | N/A |
Trunk Type | |
Colours | Grey |
Frame | Steel tubing with 1,650mm resistence |
Cab | N/A |
Trunk Type | Aluminum compartment |
Aluminium pressed pickup trunk with hinged rear panel | |
Wooden compartment | |
Wooden compartment with wood reinforcing on the edges | |
Wooden pickup trunk with wood reinforcing on the edges | |
Also available as chassis only | |
Colours | Grey |
Steering | Handlebar |
Accelerator | Actuated by twisting of the right handle bar grip |
Brakes | Front: Right lever on handlebar |
Rear: Foot pedal | |
Clutch | Left lever on handlebar |
Gears | Actuated by twisting of the left handlebar grip with clutch engaged |
Copyright © 2018-2025 - All Rights Reserved - British lambretta Archive
Design by John Walklate