Models

Lambro 175

  • Lambro 175

Lambro 175.

Technical Specification

Model Lambro 175
Production Started June 1963
Production Ended August 1965
Frame Prefix M41
Engine Prefix FLI175
Starting Frame N° 499501 (Presumed)
Starting Engine N° 460501 (presumed)
Amount Produced 22182 (Presumed)
Engine 175cc, two stroke, 62x58mm, Inside cab
Power & Rate 7HP at 4,750RPM
Compression Ratio 1:7
Head & Cylinder Aluminium & Cast Iron
Engine Cooling Forced Air
Crankcase Oil SAE 90 1600grams
Starter Kickstart or Electric
Clutch Multiple discs in oil bath
Gears 4 speed hand shifter and reverse
Gear Ratios 1st 1:28.050
2nd 1:16.107
3rd 1:10 .875
4th 1:6.875
Reverse 1:29.987
Ignition Magneto
Spark Advance 22°-24° 32-33mm on the circumfrance of the flywheel
Point Settings .35-.45mm
Sparkplug Bosch 225-240, long thread
Primary Gear
Secondary Shaft and differential
Transmission Oil SAE 90 180grams
Carburetor dell'orto MA19BS5 followed by MA19BS7
Carburation Main 80, Pilot 40, valve 60
Fuel Mix 4.00%
Fuel Consumption 1lt per 32km
Fuel Capacity 11.5lts
Range 275km
Maximum Speed 58-61km/h
Brake Type Front: Mechanically controlled drum
Rear: Hydraulically controlled drum
Tire 4.00 x 8 T
Tire Pressure Front: 2.0ATM
Rear: 3.25ATM
Front Oscillating connecting rods
Rear Rigid cross beam with longitudinal leaf springs
Dry Weight 255kg open trunk, 287kg closed compartment
Longitudinal Dimension 2,710mm
Transversal Dimension 1,330mm
Vertical Dimension Box 1,620mm
Max Hight 1,620mm
Ground Clearance 120mm
Wheel Base 1,710mm
Track Width 1,180mm
Minimum Turning Radius 1,605mm
Load Capacity 380-400kg
System 12 Volt with 18amp battery
Frame Steel tubing with 1,710mm resistence
Cab Round cab with single headlight & canvas back
Floor mats as standard.
Doors
Optional Extras
Trunk Type
Colours Grey, Blue
Frame Steel tubing with 1,710mm resistence
Cab Round cab with single headlight & canvas half back
From Frame N°489792 (A new non interchangable cab was introduced with standard doors).
Floor mats as standard.
Doors
Trunk Type Aluminum compartment
Aluminium pressed pickup trunk with hinged rear panel
Also available as chassis only
Colours Grey, Blue
Optional Extras Speedometer, Clock, Electric windshield wiper
Frame Steel tubing with 1,710mm resistence
Cab Round cab with single round headlight & canvas half back
Floor mats as standard.
Doors Optional conventional doors
Trunk Type Aluminum compartment
Aluminium pressed pickup trunk with hinged rear panel
Also available as chassis only
Colours Grey, Blue
Optional Extras Speedometer, Clock, Electric windshield wiper
Steering Handlebar
Accelerator Actuated by twisting of the right handle bar grip
Brakes Front: Foot pedal
Rear: Right lever on handlebar
Clutch Left lever on handlebar
Gears Actuated by twisting of the left handlebar grip with clutch engaged
Reverse by actuating lever on the centre column whilst not in motion with
clutch engaged and first gear selected